Search
Filters
Close

Save up to 75% off Clearance Books.  No promo code needed.  Shop Now

RP0775-1991, Preparation and Installation of Corrosion Coupons and Interpretation of Test Data in Oilfield Operations

Use of corrosion coupons in oilfield operation. Oil, water, and gas-handling systems.  Corrosivlty of various systems. Effectiveness of mitigation. Suitability of different metals. Corrosion rates. Historical document 1991

 

Product Number: 53031-HD1991
Author: NACE
Publication Date: 1991
$129.00
$129.00
$129.00

Or

This standard recommended practice was prepared to encourage the use of uniform and industry-proven methods to monitor weight loss corrosion in oilfield operations. This standard outlines procedures for preparing, analyzing, and installing metallic corrosion coupons. Factors considered in the interpretation of these corrosion coupons are also included. No Industry standards on this specific subject were previously available to oil and service company personnel. Therefore, this standard was prepared by NACE Task Group T-1 C-6, a component of Unit Committee T-1C on Detection of Corrosion in Oilfield Equipment, to provide procedures for the preparation, Installation, and interpretation of corrosion coupons. The standard was revised by Task Group T-1C-11 In 1986 and by T-1C-23 In 1991 and Is Issued by NACE under the auspices of Group Committee T-1 on Corrosion Control in Petroleum Production. Historical document 1991

This standard recommended practice was prepared to encourage the use of uniform and industry-proven methods to monitor weight loss corrosion in oilfield operations. This standard outlines procedures for preparing, analyzing, and installing metallic corrosion coupons. Factors considered in the interpretation of these corrosion coupons are also included. No Industry standards on this specific subject were previously available to oil and service company personnel. Therefore, this standard was prepared by NACE Task Group T-1 C-6, a component of Unit Committee T-1C on Detection of Corrosion in Oilfield Equipment, to provide procedures for the preparation, Installation, and interpretation of corrosion coupons. The standard was revised by Task Group T-1C-11 In 1986 and by T-1C-23 In 1991 and Is Issued by NACE under the auspices of Group Committee T-1 on Corrosion Control in Petroleum Production. Historical document 1991

Also Purchased