Search
Filters
Close

Save up to 75% off Clearance Books.  No promo code needed.  Shop Now

RP0287-HD1995-SG Field Measurement of Surface Profile of Abrasive Blast-Cleaned Steel Surfaces Using a Replica Tape-HD1995

On-site measurement of the surface profile of abrasive blast cleaned steel. Compares with lab measurements on surfaces rated as NACE Nos. 1, 2, or 3 standards. Implementation. Historical Document 1995

Product Number: 21035-HD1995
Author: NACE International
Publication Date: 1995
$129.00
$129.00
$129.00

Or

 This recommended practice describes a procedure for on-site measurement of the surface profile of abrasive blast cleaned steel surfaces that have a surface profile, as defined between 1.5 and 4.5 mils (38 and 114 µm). The procedure described has been  demonstrated to correlate well with the surface profile measurements obtained by the defined laboratory procedure on non-rusted panels prepared to a degree of cleanliness as shown in NACE Nos. 1, 2, or 3. Suggestions are given regarding the implementation and use of this procedure.

Historical Document 1995

 This recommended practice describes a procedure for on-site measurement of the surface profile of abrasive blast cleaned steel surfaces that have a surface profile, as defined between 1.5 and 4.5 mils (38 and 114 µm). The procedure described has been  demonstrated to correlate well with the surface profile measurements obtained by the defined laboratory procedure on non-rusted panels prepared to a degree of cleanliness as shown in NACE Nos. 1, 2, or 3. Suggestions are given regarding the implementation and use of this procedure.

Historical Document 1995

Also Purchased